DuraMark Preformed Thermoplastic Epoxy | Qty: 2 cans, each can is one gallon
SWARCO Preformed Thermoplastic Epoxy is a two–component adhesive system required for use on all SWARCO Preformed Thermoplastic concrete applications and all SWARCO Preformed Thermoplastic Interstate Shields, BikeLanes, Custom Logos and large mats. The SWARCO Preformed Thermoplastic Epoxy System, once combined, will cure at ambient temperature for approximately 45 minutes, the curing process is accelerated by the introduction of heat, required to properly install preformed thermoplastic. The Epoxy System is considered fully cured when it is no longer tacky to the touch.
Each Case covers 375 sq ft
STORAGE AND HANDLING
These materials should be stored in a dry environment within a
temperature range of 16° C to 27° C (60° F to 80° F). Extremes of
temperature beyond this range may result in crystallization or
polymerization of the materials. Introduction of a nitrogen blanket
into the containers before closing will improve the storage life of
the products. A wide variety of cleaning solutions are available for
cured and uncured epoxies and polyurethanes. For more
information on proper recommendations and procedures, contact
the Technical Department.
These materials are intended for industrial use only, and the
practices of good housekeeping, safety and cleanliness should be
followed before, during and after use.
Although the system contains low volatility materials, care should
be taken in handling. Use adequate ventilation in the work area.
These materials may cause dermatitis in susceptible individuals.
Keep off skin and out of eyes. In case of accidental skin contact,
wash thoroughly with soap and water. In case of eye contact, flush
eyes thoroughly with water and consult a physician immediately
SWARCO Preformed Thermoplastic Epoxy is available in gallons, quarts and 300 ml x 300 ml cartridges.